Fabrikasi Sensor Optis Non-Invasif Berbasis Modulasi Polarisasi Laser Melalui Transduksi Fotovoltaik
DOI:
https://doi.org/10.30739/jeas.v4i1.5589Keywords:
Optical Sensor, Polarimetry, Laser Polarization, Sucrose, Photovoltaic TransductionAbstract
This study fabricated and evaluated a simple optical sensor that combines a 650 nm laser diode, a polarizer–analyzer arrangement, a 1 cm cuvette, and a photovoltaic cell to detect sucrose concentration. Sucrose solutions at 0%, 5%, 10%, 15%, 20%, and 25% (w/v) were measured five times each. The average voltage increased from 252.78 mV for the sample containing 0% sucrose to 396.04 mV at a sucrose concentration of 25% (w/v). Linear regression yielded V = 264.36 + 5.77C, with a sensitivity of 5.77 mV/(% w/v), R² = 0.9637, and RMSE = 9.55 mV. The slope differed significantly from zero (p < 0.001; 95% confidence interval: 4.21–7.32 mV/(% w/v)). Repeatability showed an RSD of 0.54–3.01%, while the pooled standard deviation was 4.62 mV. A quadratic model produced R² = 0.9990 and RMSE = 1.57 mV, indicating curvature across the tested range that was not captured by the linear model. Based on the blank standard deviation and linear slope, the estimated LOD and LOQ were 0.90% and 2.74% (w/v), respectively. The prototype shows potential as a simple, low-cost optical sensor; however, further validation at low concentrations, with independent samples, temperature control, direct rotation-angle measurements, and reference methods is required.








